|
Post by stevef45 on Mar 6, 2024 15:52:25 GMT -8
I've assembled a pair if cannon air reservoirs with just the done end caps. No other details. I am trying to understand the next directions for these tiny end pieces/brackets. I can't figure it out. Does anyone have some assembly/assembled pics showing how these small parts get glued on??
|
|
|
Post by big train james on Mar 6, 2024 18:07:18 GMT -8
I don't have any photos of the assembled parts, but I do have photos of the real thing. There are two mounting brackets for each reservoir, and one drain valve for each reservoir. On the sprue, the brackets are the two outer most parts on each side, and the drain valves are closest to the middle sprue. One bracket goes on each end, and the drain valve goes on the rear end on the bottom of the tank. Technically the tanks are sloped to the rear by an inch over the length for drainage to the valve, but I don't think the Cannon brackets account for that. So presuming no slope, just make sure to mount both tanks with valves to the rear. Jim
|
|