|
|
Post by stevef45 on Sept 12, 2023 17:44:23 GMT -8
Just got my can back from shapeways. Used there sla accura extreme gray plastic. Cab looks pretty dam good. Some print lines but nothing I can't sand. There is some tackyness feeling to it. What do I clean it with? Definitely an improvement over that frosted stuff from years ago.
|
|
|
|
Post by fr8kar on Sept 13, 2023 12:33:55 GMT -8
With their old frosted material I would use a 60-second dunk in acetone to get rid of the support material. If the part was tacky at all the acetone would cure it of that. Isopropyl alcohol could accomplish the same goal but I found parts would shrink if I used it. Longer soaks in acetone would also cause shrinkage/distortion but a minute was not in the danger zone.
|
|
