nberpa
New Member
I just like running trains!
Posts: 49
|
Post by nberpa on Mar 25, 2013 6:29:58 GMT -8
Hi all,
See my next post instead......
Thanks,
Cody
|
|
nberpa
New Member
I just like running trains!
Posts: 49
|
Post by nberpa on Mar 25, 2013 7:22:42 GMT -8
Ok, scratch my first post...... I found a TCS decoder that already has resistors for LEDs (T4-LED), but it looks like it has motor control too. Since this is going in a dummy loco, is it possible to just leave the motor wires alone and just use it for lighting??
Thanks,
Cody
|
|
|
|
Post by Mark R. on Mar 25, 2013 12:17:44 GMT -8
You can, but you are going to have to add a load to the motor terminals for programming. A 100 ohm resistor works fine. When you are done programming, you either need to remove the resistor or use speed tables and set all the CV's to 0 so the resistor gets no load during operation.
Mark.
|
|
nberpa
New Member
I just like running trains!
Posts: 49
|
Post by nberpa on Mar 25, 2013 15:39:03 GMT -8
ok, Thank you!
Cody
|
|
