mdq
Full Member
Posts: 131
|
Post by mdq on Nov 4, 2024 10:19:38 GMT -8
ON the ESU V 4 and V 5 what is the CV for brake squeal? It's not coming up even when slowly coming to a stop.
I want to make it so, it does come up more then now (which is nil).
|
|
|
|
Post by jonklein611 on Nov 4, 2024 10:50:37 GMT -8
It has some logic built into it:
The LokSound decoder is able to play a wheel-synchron brakesound. To play a brake sound, there are several conditions necessary:
•The braking time in CV 4 is set sufficiently high (at least value 20 or higher).
•The loco drives with high speed at the time of the braking command.
•The loco receives the driving command “Speed step 0”.
The LokSound decoder will now start to play the braking sound at the time determined in CV 64. The higher the value in CV 64 is, the sooner the braking sound will be played. The default value 100
is approximately equivalent to speed step 48 of 128.
The braking sound should sound and end when the loco stops. You are ableto do some “finetuning” with CV 65, if the loco stops too early.
|
|
|
|
Post by jonklein611 on Nov 4, 2024 10:57:49 GMT -8
Check the value in CV 261 as well. Disable Braking sound - 64
CV 64 is the "on setpoint" If the actual loco speed step is smaller than or equals the value indicated here, the brake sound is triggered. Compare chapter 13.4.
CV 65 is the "off setpoint" If the actual loco speed step is smaller than the one indicated here (up to 255), the brake sound will be switched off again. Compare chapter 13.4
|
|
