jhall
New Member
Posts: 5
|
Post by jhall on Sept 4, 2015 13:31:56 GMT -8
Hello,
bought a Fox Valley HO GP60 DCC ready unit but am having trouble with decoder. I am using a NCE D13SRJ, with a TCS 21 pin to 9 pin harness. When I take it to the programming track, it just reads(cannot read cv). Any ideas?
Thanks,
Jeff
|
|
|
Post by bnsf971 on Sept 4, 2015 18:34:44 GMT -8
Hello,
bought a Fox Valley HO GP60 DCC ready unit but am having trouble with decoder. I am using a NCE D13SRJ, with a TCS 21 pin to 9 pin harness. When I take it to the programming track, it just reads(cannot read cv). Any ideas?
Thanks,
Jeff One time, I managed to install the 21 pin part upside down and backwards. It did something similar. Try making sure the little "blank corner" matches the adapter to the board.
|
|
jhall
New Member
Posts: 5
|
Post by jhall on Sept 6, 2015 18:26:14 GMT -8
Thanks BNSF,
That is what it was, upside down,and backwards.
Jeff
|
|