My new ALL IN ONE mounting board.
Nov 9, 2020 15:00:03 GMT -8
cf7, Colin 't Hart, and 1 more like this
Post by fishbelly on Nov 9, 2020 15:00:03 GMT -8
This is my ALL IN ONE board design to fit the Atlas/ ROCO GP38 and GP40. Probably would fit the SD35 as well.
At the front is where the ESU Power Pack sits. Then the ESU Direct Select board followed by my dual speaker enclosure design. I have included in this design some wire path routing tubes to help keep the wires in good order.
This design will glue to the top of the motor. The front portion that has the Power Pack will sit about to the middle of the cab. Underneath the middle portion is a radiused cutout to match the curvature of the motor.
At the front is where the ESU Power Pack sits. Then the ESU Direct Select board followed by my dual speaker enclosure design. I have included in this design some wire path routing tubes to help keep the wires in good order.
This design will glue to the top of the motor. The front portion that has the Power Pack will sit about to the middle of the cab. Underneath the middle portion is a radiused cutout to match the curvature of the motor.