|
Post by atsf2021bnsf on Apr 30, 2022 7:04:41 GMT -8
I junked my old Lenz system and have a brand new Digitrax Zephyr Express. Most of my engines run fine BUT I have three Bowser SD40-2's and a Scaletrains SD40-2, all with the factory set address "3" where everything works but they will not move. The motor sound notches up as you open the throttle but all remain stationary. I set about trying to change one loco's address to its road number. That did not change running. I then did a factory reset cv8 = 8 and it went back to responding to address 3 but still no movement.
Any suggestions ? I also found that when I tried to reset cv8 a few times I got error messages "program track empty" though it contained a loco where all sounds and lights were functioning fine. Goodness this is frustrating. JM
|
|
|
Post by Mark R. on May 2, 2022 7:13:36 GMT -8
There are a few functions that would cause that if they were turned on. Go through ALL the function listings and make sure they are all turned off first.
Mark.
|
|
|
Post by atsf2021bnsf on May 2, 2022 8:21:04 GMT -8
Thanks Mark. Finally got them all working. Dunno what changed but one thing I did is that I shortened the programming track to just one section of about 12 inches. P{riot to that I was trying to programme using the whole length of the test track of about 10 feet. maybe this as dissipating the signal producing an error message. JM
|
|